Pmod SSR Reference Manual
The Digilent Pmod SSR (Revision B) is a solid state relay that featuresIXYS' CPC1908J. The Pmod SSR uses a switch controlled by a singleGPIOpin and is rated to block up to 48 Volts and switch up to 6 Armscontinuous current.
Download This Reference Manual
Features
-
0-48 V blocking voltage
-
Can switch up to 6 Armscontinous current
-
2500 V input/output isolation
-
Low on resistance with fast turn on/off
-
OnboardLEDto indicate on/off state
-
Onboard terminal block for easy wire connection
-
Small PCB size for flexible designs 1.7“ × 0.8” (4.3 cm × 2.0 cm)
-
6-pin Pmod Connector withGPIOinterface
-
Follows the Digilent Pmod Interface Specification Type 1
-
Libraries and example code available in resource center
Functional Description
Pmod SSR使用ingleGPIOpin to establish a connection between two terminals.
Specifications
| Parameter | Value | Units | ||
|---|---|---|---|---|
| Maximum Blocking Voltage | 48 | VP | ||
| Maximum Peak Current (t⇐10ms) | 25 | AP | ||
| Maximum Continuous Current (25C Ambient, 400 LFPM airflow) | 6.2 | Arms/ ADC | ||
| Maximum Continuous Current (25C Ambient, no airflow) | 3.8 | Arms/ ADC | ||
| Parameter | Min | Typical | Max | Units |
| 导通电阻 | - | 0.09 | 0.3 | Ω |
| Turn-On Switching Speed | - | 16 | 20 | ms |
| Turn-Off Switching Speed | - | 0.17 | 5 | ms |
| Input Control Current for Activation | - | - | 10 | mA |
| Input Control Current for Deactivation | 0.6 | - | - | mA |
Interfacing with the Pmod
The Pmod SSR communicates with the host board via aGPIOpin. To open the relay, the ON pin must be driven to a logic high state. To close the relay, the ON pin must be driven to a logic low state.
Pinout Description Table
| Pin | Signal | Description |
|---|---|---|
| 1 | ON | Switch Control |
| 2 | NC | Not Connected |
| 3 | NC | Not Connected |
| 4 | NC | Not Connected |
| 5 | GND | Power Supply Ground |
| 6 | VCC | Power Supply (3.3/5 V) |
Physical Dimensions
The pins on the pin header are spaced 100 mil apart. The PCB is 1.7 inches long on the sides parallel to the pins on the pin header and 0.8 inches long on the sides perpendicular to the pin header. The overall height of the Pmod including the heat sink, PCB, and components on the underside of the PCB is 0.75 inches.
Additional Information
The schematics of the Pmod SSR are availablehere. Additional information about the Solid State Relay itself including switching speeds can be found on it's datasheethere.
Example code demonstrating how to use the Pmod SSR can be found at thePmod SSR Resource Center.
If you have any questions or comments about the Pmod SSR, feel free to post them under the appropriate section (“Add-on Boards”) of theDigilent Forum.