The JTAG-HS3 is an affordable high-speed Xilinx®FPGA编程解决方案。HS3通过在PIN 14中添加开放式缓冲液，从而在成功的JTAG-HS1上构建HS3，从而可以调试Xilinx Zynq-Soc处理器。它可以使用Xilinx的2x7 Connector*将其连接到目标板上，并且与所有Xilinx工具（包括Impact™，Chipscope™和EDK）兼容。
When connected to a PC via a standard A to micro-USB cable, the JTAG HS3 receives its power from USB and can be recognized as a Digilent programming cable, even if the HS3 is not attached to the target board. The JTAG bus can be shared with other devices as the HS3's signals are held in high-impedance, except when actively driven during programming. The HS3 is small and light, allowing it to be held firmly in place by the system board connector.
*这是一个独特的编程header and is not compatible with the 1x6 MTE Digilent JTAG Connector.
Note:Digilent FPGA板不需要此电缆，因为我们的板使用集成的编程电路设计。
- Small, complete, all-in-one JTAG programming/debugging solution for Xilinx FPGAs and SoCs
- Plugs directly into standard Xilinx JTAG 2.0 mm pitch header
- Separate Vref drives JTAG signal voltages; Vref can be any voltage between 1.8V and 5V
- 高速USB2端口，可以将JTAG总线驱动到30mbit/sec（用户可调节频率）
- 与xilinx ise兼容®14.1和新的，xilinx vivado®2013.3 and newer
- 使用USB Micro-B连接器
- 引脚14上的开放式缓冲区允许调试软件重置Xilinx的Zynq平台的处理器核心
- Product Compliance:
- HTC:8473301180
- ECCN:Ear99
- 一台JTAG-HS3编程电缆。
- 与xilinx ise兼容14.1和新的，xilinx vivado2013.3 and newer, iMPACT, ChipScope, and EDK.
