Pmod LS1
Buy
Reference Manual
Technical Support
Pmod LS1
Infrared Light Detector
Features
- Infrared light detector with on-board sensitivity adjustment
- Interface with up to four reflective or transmissive photo detectors
- Works with Digilent IR Proximity Sensor
- 6-pin Pmod connector withGPIOinterface
- Follows the DigilentPmod Interface SpecificationType 1
Physical
Width
1.4 in (3.56 cm)
Length
0.80 in (2.03 cm)
J1 Pinout
Pin 1
S1
Pin 2
S2
Pin 3
S3
Pin 4
S4
Pin 5
GND
Pin 6
VCC
The Digilent Pmod LS1 (Revision B) allows users to receive signals from multiple optical sensors, such as the popular combination of an IRLEDwith an IR sensor used in line-following robots.
Example Projects
-
Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier.
Microprocessor
-
线后merck机器人3 d公关inted parts- Community Project
-
Line Following SRK Robot with 3d printed parts- Community Project
-
Digilent MRK + Line-Following Robot Assembly Instructions- Community Project
-
Using the Pmod LS1 with Arduino Uno- Application note
Programmable Logic
-
No programmable logic example projects are available for the Pmod LS1
Reference Projects
Additional Resources
-
Specification Version 1.2.0:PDF