Pmod BLE

Buy Reference Manual Technical Support
Pmod BLE
Bluetooth Interface
Features
  • Fully Qualified Bluetooth® Low Energy Module
  • On-Board Bluetooth 4.2 Low Energy Stack
  • Certified to FCC, IC, CE, KCC, NCC and SRRC
  • ASCIICommand InterfaceAPI
  • Secure communication AES128 Encryption
  • Remote Configuration Over The Air
  • Small PCB size for flexible designs 1.0“ x 0.8” (2.57 cm × 2.03 cm)
  • 12-pin Pmod connector with UART interface
  • Follows Digilent Pmod Interface Specification Type 3A
Electrical
Bus
UART
Specification Version
1.2.0
Logic Level
3.3 v
Physical
Width
1.5 in (3.81 cm)
Length
0.80 in (2.03 cm)
Documentation
Primary IC
RN4871
Reference Manual
Pmod BLE Reference Manual
Schematic
J1 Pinout
Pin 1
RTS
Pin 2
RXD
Pin 3
TXD
Pin 4
CTS
Pin 5
GND
Pin 6
VCC
Pin 7
GPIO
Pin 8
RST_N
Pin 9
MODE
Pin 10
STATUS
Pin 11
GND
Pin 12
VCC
Product Compliance
HTC
8517620090
ECCN
5A992.c

The Digilent Pmod BLE (Revision A) is a powerful peripheral module meant for use with any UART enabled development board. This Pmod employs the Roving Networks RN4871 to create a fully integrated Bluetooth Low Energy interface. This chip features an onboard Bluetooth stack that makes connecting and communicating with any Bluetooth 4.0+ device possible through simple UART commands. The RN4871 also features four built in GATT services: Device Information, Airpatch, BeaconThings, and UART Transparent data streaming. It also allows up to five custom public services and up to 4 custom private services, each allowing up to eight custom characteristics. The PmodBLE is a cheap, versatile, low energy addition to the wireless Pmod library.



Example Projects

Microprocessor
Programmable Logic

Additional Resources

,,,,,