Sword

Reference Manual Technical Support

Sword

Kintex-7 FPGA开发板

Features

Wide variety of memory devices and I/O

Programmable from JTAG and Quad-SPI flash

Key Specifications

FPGA Part #

XC7K325T-2FFG900C

Logic Slices

50,950 slices

Block RAM

2002.5 KBytes

DSP slices

840 DSP slices

CMTs

10 clock management tiles

DDR3

1024MB @ 1800Mbps with 32-bit data width

Internal clock

700MHz+

Quad-SPI Flash

32MB

SRAM

2MB and 4MB SRAMs with a shared 32-bit address bus

Parallel Flash

32MBwith 32-bit data width

Connectivity and On-board I/O

Pmod Connectors

4 Pmod ports

VGA

1 VGA connector

HDMI

HDMI Sink and HDMI Source

SD

microSD card connector

USB

HID host for mouse, keyboard,
and user USB
USB-JTAG Programmer

Audio

Audio codec with four 3.5mm jacks

Ethernet

10/100/1000 PHY

SFP+

2 10Gbps SFP+ PHY interfaces

RS232

1 DB9F RS232 connector

Shield Connector

Arduino / chipKITcompatible

Seven Segment Display

8 digits

LEDs

16 LEDs, 2 RGB LEDs

Switches

16 slide switches

Buttons

2 resets
25 button keypad

Electrical

Power

12V ±5 % external power only (PCIE connector)

Physical

Width

7-1/8 in

Length

9-1/16 in

Powered by Xilinx's Kintex-7 XC7K325T FPGA, the Sword board provides a wide variety of onboard peripherals, memory devices and I/O. Additional expansion connectors in the form of Pmod connectors and a Chipkit/Arduino header make the potential uses for the Sword board nearly limitless.

Wide high-speed memory interfaces in the form of two SRAMs with a shared address bus and a 1GB DDR3 provide a powerful environment for experimenting with different memory architectures. In addition, these memories provide good support for common networking applications.

The Sword board's Kintex-7 XC7K325T FPGA is compatible with Xilinx’s high-performance Vivado® Design Suite and requires the full software license. WebPack is not supported. Licensing information for Vivado can be foundhere. Academic institutes can request full Vivado licenseshere.